Texecom Premier Elite 24

Premier Elite Series User Guide
INS221-4 7
The Turn CHIME On and Off
The system can be set up so that activating (opening) certain zones will cause the internal sounders to chime. This
would normally be used on a front door, exit button etc.
 Zones will only cause the internal sounders to chime if they are selected for chime (see page Master User Guide for details
on selecting which zones chime).
Once a zone has been selected for chime, the Chime facility can be manually turned on and off as required.
 The system can also be programmed to automatically turn chime on and off under certain conditions i.e. certain times of
the day, door left open etc.
If no zones have been programmed for Chime, then turning Chime on and off will have no effect.
To turn CHIME On To turn CHIME Off
1. Press

1. Press

The Chime tone will sound.
The Error tone will sound.
To CHANGE Your User Code
Users with access to this option can change their own User codes. User codes are unique to each user and can be
4, 5 or 6 digits long.
 Only the User code that is entered to access the change code menu will be changed.
Before changing your code, it is vital that you memorise or write down the new code you are about to
program. Failure to remember your code will require an engineer visit to re-program a new code for you. This
may incur a call-out charge.
1. Enter the User code that requires changing

2. Press

3. Press

4. Press

5. Press

6. Enter a new 4, 5 or 6-digit User code

7. Press

to accept the new code
8. Press

to exit the menu The display will return to normal.
Using a Proximity Tag
General Operation
1. A Proximity TAG must be held over the PROX symbol on the keypad.
2. A Proximity TAG will normally work at distances of up to 4cm, however it should be noted that distances can
and do vary.
3. Presenting a Proximity TAG to the keypad is NO different to entering a code except that it is a SINGLE action as
opposed to a MULTIPLE action.
4. The control panel will log which User/TAG has been presented.
Programming Proximity TAGS
Programming a Proximity TAG will depend on which type of control panel and what version of software is installed
(Your Installation Company can advise if it is possible to use Tag’s on your system).Operation