Texecom Veritas R8Plus - Programming Access Codes; Changing Your Own Access Code; Assigning a New Access Code; Displaying Your User Number

Master User Guide Programming Access Codes
INS140-2 5
Programming Access Codes
Each user has a programmable 4 digit Access code which the user
enters in order to operate the alarm system.
Changing Your Own Access Code
&-
Every user has the ability to change their own 4 digit Access code, as
follows:
From the Unset State:
1) Enter your existing Access code
''''
2) Press PROG to access the Programming Menu
.
3) Enter 60 to select the Change Your Access code option
&-
4) Enter your new 4 digit Access Code
''''
5) Press PROG, the system will chime to confirm your new code
.
6) Press RESET to revert to the unset state
/
Assigning a New Access Code
&!
–
&,
The Master User can assign a new Access code or change an existing
Access code providing it is a Customer Type. The Boss Engineer can
assign a new Access code or change an existing Access code providing
it is a Installer Type.
From the Unset State:
1) Enter your Access code (Master User or Boss Engineer only)
''''
2) Press PROG to access the Programming Menu
.
3) Enter 6 to select the Change Access code option
&
4) Enter the User Number (1 - 8) you wish to change, e.g. 5
%
5) Enter their new 4 digit Access code
''''
6) Press PROG, the system will chime to confirm the new code
.
7) Press RESET to revert to the unset state
/
Displaying Your User Number
&0
Each user is identified by the alarm system as User 1 through to User 8.
Every user may view their User Number (1 - 8) as follows: