Texi Art Auto 2 - Page 6

No. Items Range Default Description
P21
The position of the pedal for
running
30-1000 520
P22
The position of the pedal for the
stop
30-1000 420
P23
The position of the pedal for
lifting presser foot
30-1000 270
P24
The position of the pedal for
thread trimming
30-500 130
P27
Pattern freedom sewing editing
P29
The strength of thread trimming
stop
1-45
20
P32
Bar-tacking compensation 5 0-200 167
P34
Constant-stitch sewing running
mode selection
A/M A
A：Automatically perform actions
M：Could be arbitrarily stop and start
P36
Thread slacking function
selection
0-1 0
0: OFF
1: ON
P37
Automatic thread wiping
function / Automatic thread
clamping function selection
0-11
6
0 : OFF
1: Automatic thread wiping Function
2-11: Automatic thread clamping Function and the strength of automatic
thread clamping.
P38
Automatic thread trimming
function selection
ON/OFF
ON
P39
Automatic presser foot lifting
when pause function selection
UP/DN DN
P40
Automatic presser foot lifting
after trimming function
selection
UP/DN DN
P41
Counter display 0-9999 0
Display the quantity of finished sewing piece.
Long-press “-” key to clear
the count
P42-N01
The control system version
number
P42-N02
The panel version number
P42-N03
Speed
P42-N04
The pedal AD
P42-N05
The mechanical angle(up
position)
P42-N07
Bus bar voltage AD
P42-N15
Step drive version number
P44
Brake strength during stopover
1-45
16
P46
Motor stop with a reverse angle
after trimming function
ON/OFF
OFF
P47
Adjust the reverse angle when
motor stop after trimming
10-50
40
Adjusting at reverse direction after trimming.
P48 The minimum speed limit (rpm ) 100-500
210
Adjust the minimum speed
P49 Thread trimming speed (rpm) 100-500
300
Adjust thread trimming speed
P50
Toot lifter operation time to full
output (ms)
10-990
200