Texi Tegra 4 - 2-Thread Spreader Installation

EN
2-THREAD SPREADER INSTALLATION
NOTE: TURN OFF THE POWER.
Sewing 2-thread, 3-thread, 4-thread,
must be installed 2-thread spreader. The
2-thread spreader is put in the accessories
box.
Insert the hinge A in the 2-thread
spreader into the hole in the upper
looper.
Turn the 2-thread spreader to
the left and press the upper part
slightly back. The tip of the 2-thread
spreader will be locked in the
hole of the upper looper. With the
reverse step, you can remove the
2-thread spreader.
The hand wheel rotates along the
direction of the arrow until upper looper
is on the right side of upper knife.
Texi Tegra 4
88
Texi Tegra 4 INSTRUKCJA 2019.indb 88Texi Tegra 4 INSTRUKCJA 2019.indb 88 18.09.2020 09:4218.09.2020 09:42