TEXI Tronic 7 NF operation manual
29. Micro-lifting mechanism of the presser foot
Warning: Turn OFF the power before starting the work as to prevent accident caused by abrupt start of the sewing
machine.
When sewing velvet or the like which is fluffy, slippage of
material or damage of material is reduced by using screw
(1) for presser foot micro-lifting.
Gradually tighten screw (1) for presser foot micro-lifting in
the state that nut (2) is loosened, adjust the presser foot to
the position where it is finely lifted until it matches the
material, and fix it with nut (2).
Caution: when the presser foot micro-lifting mechanism is
not used, adjust the height of screw (1) so that it is higher
by approximately 11 mm than the sewing machine. If the
sewing machine is operated in the state that the microlifting
mechanism is working, sufficient feed force cannot be
obtained.
30. Caution when carrying or placing the sewing machine
How to carry the sewing machine
Carry the sewing machine with two persons as shown in the
figure.
Caution: Do not hold the hand-wheel.
Caution when placing the sewing machine
Do not place any protruding thing such as screwdriver or the
like on the place where the sewing machine is set.
20
To Next Page
Loading...
Need help?
General
