Electrical Installation
Check the power supply voltage and frequency and compare with the product requirements
specified on the name plate
Observe relevant EB regulations while giving power supply to the motor
Ground the monoblock using the two earth screws provided on the leg of the motor body
Ensure electrical joints, if any, are properly and adequately insulated
Connect the cable properly to the starter terminals to avoid loose connections
Factor in low voltage operation while selecting cable size
Electrical wiring work
Warning
All electrical work must be performed by an authorised electrician in compliance with
local electrical equipment standards and internal wiring codes. Improper wiring can
lead to current leakage, electrical shock, or fire.
Earthing
Warning
Be sure to install the ground wire securely. Failure to observe this precaution could
damage the pump and cause current leakage, which may lead to electrical shock.
Caution
Do not connect the ground wire to a gas pipe, water pipe, lightning rod, or telephone
ground wire. Improper grounding could cause electrical shock.
OMMM001A 18 2020.01
To Next Page
Loading...
