The motors are internally wired and pre-connected with the capacitor
Connect phase and neutral to the terminal board
In case of clarification, please refer to the Connection Diagram displayed in the inner side of the
terminal box cover
Connecting the Power Supply
Caution
Observe relevant Electricity Board regulations while powering up the pump set
Warning
Before connecting the wires to the terminal board, make sure the power supply is
properly disconnected. Failure to do so may lead to electrical shock, short, or injury
caused by the unintended starting of the pump
Caution
Do not use damaged cables, power plugs, or loose power outlets. Failure to observe
this precaution could lead to electrical shock, short circuit or fire
Supply connection to single phase monoblock
OMMM001A 19 2020.01
To Next Page
Loading...
