BHT-206L3-MM-1
5-00-00
Page 80 Rev. 22 15 MAY 2015 Export Classification C, ECCN EAR99
10. Examine lower fuselage for indication of fuel leaks, dents,
cracks, corrosion, delamination, loose or missing rivets, and
condition.
11. Inspect external area of fuel boost pump for interference of
wire from low fuel warning switch to fuel boost pump retainer.
12. Examine all fuselage sealant joints for condition. Restore
sealant as necessary.
Chapter 96 and
Chapter 97
ELECTRICAL AND AVIONICS
1. Examine all visible electrical components, wires, cables,
and connectors in the area of the forward fuselage for chafing,
and general condition and security.
2. Remove battery and recondition in accordance with
BHT-ALL-SPM and manufacturer’s service manual.
3. Examine battery vent tubes for obstruction or damage.
4. Perform operational test of the battery temperature
indicating system.
5. If battery was removed, clean mounting area prior to
installing serviceable battery.
6. Verify operation of litter door open warning light.
7. Verify operation of landing lights.
8. Verify operation of lower fuselage mounted position lights
(if installed).
9. Examine antennas for condition and security.
5-25. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 5 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...