Textron Bell 206L3 - COMPONENT OVERHAUL SCHEDULE 5-60. COMPONENT OVERHAUL SCHEDULE; Table 5-4. Component Overhaul Schedule

BHT-206L3-MM-1
5-00-00
10 MAR 2017 Rev. 23 Page 195
Export Classification C, ECCN EAR99
COMPONENT OVERHAUL SCHEDULE
5-60. COMPONENT OVERHAUL SCHEDULE
The Component Overhaul Schedule (Tab le 5- 4)
provides the time interval between overhaul for each
applicable helicopter component.
WARNING
DO NOT APPLY TOLERANCES TO
PARTS WITH A LIMITED
AIRWORTHINESS LIFE (CHAPTER 4).
WARNING
DO NOT EXCEED RETIREMENT LIFE
FOR CRITICAL COMPONENTS. REFER
TO AIRWORTHINESS LIMITATIONS
SCHEDULE (CHAPTER 4).
SOME PARTS INSTALLED AS ORIGINAL
EQUIPMENT ON MILITARY
HELICOPTERS MAY HAVE A LOWER
AIRWORTHINESS LIFE AND/OR
OVERHAUL SCHEDULE THAN WHEN
USED ON A COMMERCIAL
HELICOPTER. CONSEQUENTLY, PARTS
THAT HAVE BEEN USED ON MILITARY
HELICOPTERS SHOULD NOT BE USED
ON COMMERCIAL HELICOPTERS.
CAUTION
OVERHAUL SCHEDULE FOR SOME KIT
COMPONENTS AND/OR PARTS IS NOT
COVERED IN THIS SCHEDULE. REFER
TO APPLICABLE SERVICE
INSTRUCTIONS FOR KIT COMPONENTS
SCHEDULE.
NOTE
Refer to paragraph 5-6 for information on
inspection and overhaul tolerance.
NOTE
Neither assignment of a time period for
overhaul of a component or failure to
assign a time period for overhaul of a
component constitutes a warranty of any
kind. The only warranty applicable to
helicopter and any component is that
warranty included in the Purchase
Agreement for the helicopter or component.
The overhaul interval specified for any given part
number contained in this Component Overhaul
Schedule applies to all successive dash numbers (or
suffixes) for that item unless otherwise specified.
Table 5-4. Component Overhaul Schedule
NOMENCLATURE PART NUMBER
OVERHAUL INTERVAL
(HOURS)
MAIN ROTOR CONTROLS
Swashplate and Support
Assembly
206-010-450-101 4800 hours
MAIN ROTOR HUB
Main Rotor Hub Assembly 206-011-100-159/-105 2400 hours
1