Textron Bell 206L3 - SCHEDULED INSPECTIONS 5-42. 1500 HOURS OF COMPONENT OPERATION; FREEWHEEL ASSEMBLY (WITH CLUTCH CL42250-1)

BHT-206L3-MM-1
5-00-00
Page 132 Rev. 16 25 FEB 2011
ECCN EAR99
Chapter 63 1. Remove transmission.
2. Remove mast assembly, oil filter, and housing assembly.
Inspect oil filter for debris and metal contamination.
BHT-206L-CR&O 3. Remove top case, planetary, and sun gear.
4. Perform a sun gear special inspection.
NOTE
Penetrant inspection not required for top case
(206-040-550-101).
5. Penetrant inspect transmission top case. Stripping paint
from exterior surface is not required.
BHT-206L-CR&O 6. Install sun gear, planetary, and top case.
Chapter 63 7. Install mast, oil filter, and transmission.
FREEWHEEL ASSEMBLY (WITH CLUTCH CL42250-1)
Chapter 63 1. Remove freewheel assembly.
BHT-206L-CR&O 2. Disassemble the freewheel assembly to the extent
necessary to perform a visual inspection of the clutch assembly,
inner shaft, and outer shaft. It is not necessary to remove the
thrust bearing from the outer shaft. Remove all sealant and
clean all parts. The stripping of paint is not required.
3. Visually inspect clutch assembly, inner and outer race shaft
assemblies, and bearings for serviceability.
4. Assemble freewheel assembly.
Chapter 63 5. Install freewheel assembly.
SCHEDULED INSPECTIONS
5-42. 1500 HOURS OF COMPONENT OPERATION (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER