Textron Bell 206L3 - PROGRESSIVE INSPECTIONS 5-17. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION - EVENT NO. 2; ZONE 4 - POWER PLANT; AIRFRAME (POWER PLANT AREA)

BHT-206L3-MM-1
5-00-00
25 FEB 2011 Rev. 16 Page 27
ECCN EAR99
PROGRESSIVE INSPECTIONS
5-17. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 2
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
DATE: __________________W.O. _____________________
FACILITY: __________________________________________
HELICOPTER S/N: ___________________________________
REGISTRY NO.: _____________________________________
TOTAL TIME:_______________________________________
SIGNATURE:________________________________________
ZONE 4 — POWER PLANT
Chapter 11 PLACARDS AND MARKINGS
1. Examine the placards, decals and markings. Ensure they
are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
AIRFRAME (POWER PLANT AREA)
Chapter 71 1. Examine firewalls for condition and security.
2. Examine engine pan area for evidence of loose fasteners
and damage. Restore cracked or missing sealant form engine
pan.
3. Examine engine pan drains. Make sure that they are not
clogged.
Chapter 28 4. Examine airframe fuel filter assembly for evidence of
leakage and security.
Chapter 71 5. Examine engine mount legs for condition and security. Pay
particular attention for loose fasteners.
6. Examine engine mount fittings for condition and security.
Applicable Service
Instruction
7. Examine rotor brake (if installed) for condition and security.