BHT-206L3-MM-1
5-00-00
Page 32 Rev. 17 8 APR 2011
ECCN EAR99
5. Examine aft short shaft (aluminium) splined adapter for
adequate lubrication and freedom of movement.
6. Torque check disc pack coupling fasteners 50 to
70 inch-pounds (5.7 to 7.9 Nm).
Chapter 96 ELECTRICAL
1. Examine all electrical components, wires, cables, and
connectors in the area of the aft deck for chafing, and general
condition and security.
GROUND RUN
GROUND RUN OF HELICOPTER TO BE
ACCOMPLISHED BY QUALIFIED PERSONNEL
ONLY.
Chapter 12 1. Make sure applicable servicing requirements have been
carried out.
2. Check oil level of transmission, hydraulic tank, engine and
rail rotor gearbox prior to running helicopter.
3. Make sure that helicopter is ready for ground run and that
surrounding area is clear.
BHT-206L3-FM-1
(BHT-206L4-FM-1 for
206L3+ IGW
Upgrade)
4. Start the helicopter and conduct ground run at 100% N
R
to
check for leaks and ensure all systems are operational and
parameters are within Flight Manual limitations.
5-17. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 2 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...