BHT-206L3-MM-1
5-00-00
25 FEB 2011 Rev. 16 Page 41
ECCN EAR99
3. Verify operation of the pitot tube heating system.
4. Verify operation of defog blowers.
5. Verify operation of ENGINE OUT and LOW ROTOR RPM
audio and mute switch (if installed).
6. Verify illumination of all caution panel annunciator light
segments by depressing test switch, or each individual light
segment, as applicable.
7. Verify instrument lighting and dimming capabilities.
ZONE 8 — FORWARD FUSELAGE
PLACARDS AND MARKINGS
Chapter 11 1. Examine the placards, decals and markings. Ensure they
are readable, correctly applied and in agreement with the
applicable configuration of your helicopter.
FUSELAGE
Chapter 53 1. Examine forward fuselage for condition.
Chapter 52 2. Examine all cabin doors for condition and security. Give
special attention to the following
a. Hinges
b. Seals
c. Latches for proper adjustment, positive locking, and
wear
d. Windows
e. Handles
Chapter 95 3. Drain moisture from pitot and static piping installation.
Chapter 53 4. Examine the external power door and receptacle for
condition and security.
5-19. 100-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 4 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...