Textron BUNTON BZT 2000 Series - Page 26

24
BZT 2000
Series
SPECIFICATIONS
SKCEDRETTUC
REBMUNLEDOM022246
222246,122246
722246
332246,322246
822246
EPYT
egrahcsiDediSegrahcsiDediSegrahcsiDediS
HTDIWGNITTUC
)mc021("52.74)mc331("5.25)mc551("16
HTDIW
A/NA/NA/N
)PUETUHC(HTDIW
)mc731("45)mc341("52.65)mc751("26
ETUHC(HTDIW
)NWOD
)mc051("95)mc461("5.46)mc581("37
TINUGNITTUC
edalbtfilhgihenO
)lanoitpotfilwol(
edalbtfilhgihenO
)lanoitpotfilwol(
edalbtfilhgihenO
)lanoitpotfilwol(
FOREBMUN
STINUGNITTUC
333
HTGNELEDALB
)mc14("52.61)mc64("81)mc35("12
SSENKCIHTEDALB
)mm2.5("502.)mm2.5("502.)mm53.6("52.0
DEEPSPIT
nim/tf48761
nim/m6115
nim/tf49651
nim/m4874
nim/tf01381
nim/m0855
NOITCUDORPYLIAD
)hpm6@rh8(
serca9.22otpU
)ah3.9(
serca5.52otpU
)ah3.01(
serca5.92otpU
)ah9.11(
CONSTRUCTION:
Fabricated and welded or bolted 10-gauge, double-
layer steel top with 7-gauge side skirts. Full floating
design.
CUTTERDECK DRIVE SYSTEM:
Electric clutch/brake drives belt directly from engine
to center spindle of cutterdeck. No twists in drive
belt.
SPINDLES:
Top mounted and maintenance free, with 1" shaft in
precision machined, aluminum housing
ANTI-SCALP ROLLERS:
48" Cutterdecks - 3 Rollers
52" Cutterdecks - 7 Rollers
61" Cutterdecks - 8 Rollers
CUTTING HEIGHT & PRODUCTION:
Height: Spring assisted lift lever allows easy setting
of cut heights from 1-1/2” to 4-1/2” in 1/4” increments.
“Set and forget” feature allows height of cut to be set
and returned to without searching from operator
position.
NOTE: 48” cutterdecks do not use spring assisted lift
levers.
SPECIFIC TORQUES
BLADE BOLT TORQUE: 70 FT-LBS (95 Nm)
WHEEL HUB NUTS: 225 FT-LBS (237 Nm)
ENGINE CRANKSHAFT BOLT: 50 FT-LBS (68 Nm)