EasyManua.ls Logo

Textron Cessna Skyhawk SP - Before Takeoff

Textron Cessna Skyhawk SP
322 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CESSNA SECTION 4
MODEL 172S NAV III NORMAL PROCEDURES
GFC 700 AFCS
U.S.
STARTING ENGINE (With External Power) (Continued)
f. M BATT Ammeter - CHECK (verify battery charging, amps
positive)
g. LOW VOLTS Annunciator - CHECK (verify annunciator is
not shown)
WARNING
IF M BATT AMMETER DOES NOT SHOW POSITIVE
CHARGE (+ AMPS), OR LOW VOLTS ANNUNCIATOR
DOES NOT GO OFF, REMOVE THE BATTERY FROM
THE AIRPLANE AND SERVICE OR REPLACE THE
BATTERY BEFORE FLIGHT.
28. NAV Light Switch - ON (as required)
29. AVIONICS Switch (BUS 1 and BUS 2) - ON
BEFORE TAKEOFF
1. Parking Brake - SET
2. Pilot and Passenger Seat Backs - MOST UPRIGHT POSITION
3. Seats and Seat Belts - CHECK SECURE
4. Cabin Doors - CLOSED and LOCKED
5. Flight Controls - FREE and CORRECT
6. Flight Instruments (PFD) - CHECK (no red X's)
7. Altimeters:
a. PFD (BARO) - SET
b. Standby Altimeter - SET
8. ALT SEL - SET
9. Standby Flight Instruments - CHECK
10. Fuel Quantity - CHECK (verify level is correct)
NOTE
Flight is not recommended when both fuel quantity
indicators are in the yellow band range.
11. Mixture Control - RICH
12. FUEL SELECTOR Valve - SET BOTH
(Continued Next Page)
172SPHBUS-02
4-15

Table of Contents