2
21. Always use pots with covers and make sure that the handles of the pots are correctly positioned to
avoid heating and collision of handles.
22. Do not use sprays near the appliance.
23. All control knobs should be turned to off position “ ● ”after use.
24. In case of cooking spillage, clean appliance properly once it cools down.
25. If abnormal noise is observed, turn off flame. Check placement of burner caps and burner bodies and
place them correctly after appliance cools down, ignite again. Contact Towngas Company for
inspection if problem persists.
26. The top plate of this gas appliance is made of ceramic glass which is safer than normal glass.
However, the following safety precautions should be noted in order to prevent the glass top
breakage:
Do not use oversized utensils for cooking, e.g. grill plate.
Dot not impact the glass top with hard objects or place heavy objects on it.
Dot not place cooking utensils on the glass top.
Maintenance
1. Check condition of gas hose regularly. Ensure that it is free from kink or crack. Contact Towngas
Company to replace it if damage is found.
2. Allow the appliance to cool down completely before cleaning.
3. Wear gloves to protect the hands from cut injury when cleaning the appliance.
4. Dry burner caps and burner bodies completely with dry cloth after washing. Burner flame holes must
be free from water lest combustion is affected.
5. Before and after use, notice the condition and cleanliness of burners. The following abnormal
conditions will incur abnormal combustion and thus damage of the appliance. Ensure undertaking
measures to rectify the problem accordingly.
Important Safety Instructions
Abnormal Condition Handling Measure
Burner caps and burner bodies are deformed Contact Towngas Company for services.
Burner caps and burner bodies are tilted
Replace burner caps and burner bodies
properly without tilting.
Burner flame holes are blocked by water
Dry burner caps and burner bodies with cloth
and replace them properly.
Burner flame holes are blocked by dirt
Clean burner caps and burner bodies with
mild detergent and brush. Dry them with cloth
and replace them properly.
To Next Page
Loading...
