7
Operation Instructions
Turning off Flame
Turn the control knob to the off position“ ● ”.
Attention: Pop sound may be generated when turning
off flame due to the instant combustion of gas
remained in burner. This is a normal phenomenon.
OFF Position
Ignition
Position
Flame Control
After ignition, turn the control knob to adjust flame power.
Ignition of Burner
Ensure the control knob is at the off position “ ● ”Press and turn the
knob in anti-clockwise direction to ignition position. Sparks are
maintained for around 10 seconds for ignition. After releasing the
knob, make sure the flame persists.
Attention: If the appliance has not been used for a long time, the
first ignition may not succeed due to trapped air in gas pipe.
Turn the control knob to the off position“ ● ”. Repeat the above
ignition procedures until success of ignition.
Outer Burner Flame
Simmer Burner Flame
Flame Condition
Knob Position
Large
Large
Large Small Medium
Medium OFF
OFF
OFF OFF OFF
OFF
MAX.
MIN. MIN.
MIN.
MIN.
To Next Page
Loading...
