7
NAV/PM1 Encoder
[to navigate within the menus]
NAV/PM1 Enc PM2 Enc. PM3 Enc.
[to choose values for the parameters, no need to conrm the chosen
values, which are automatically loaded during the encoders use]
3.2 Out-[X]
->1.00 kHz
[Name]
(-6/-12)
LoSh
+0.0dB
EQ-X
(up to
7 lters
available)
[Freq.] 20Hz
:
20kHz
PM2 N/A
[Amp.] -15.0dB
:
+15.0dB
If through the PM2, being the
lter’s gain = 0.0dB, has been
selected a high shelving lter, just
dening its Slope (1
st
or 2
nd
order
available, -6dB or -12dB), then the
high shelving lter can be set by
the following parameters
3.3 Out-[X]
–
>1.00 kHz
[Name]
(-6/-12)
HiSh
+0.0dB
EQ-X
(up to
7 lters
available)
[Freq.] 20Hz
:
20kHz
PM2 N/A
[Amp.] -15.0dB
:
+15.0dB
4 Out-[X]
VU-Meter
=
[Name]
Level
VU-Meter
–
> VU-Meter = Level PAR1 N/A Level
Limiter Act.
Same as PAR2
5 Out-[X]
Name
=
[Name]
[Name]
Name
–
> Name = – (For editing the device’s name, refer to the details in chapter
“Utility menus use”)
6 Out-[X]
Source
=
[Name]
InA
Source
–
> Source = InA PAR1 N/A InA (Channel A) Same as PAR2
InB (Channel B)
InA+InB (Channel A+ Channel B)
7 Out-[X]
Gain
=
[Name]
+0.0 dB
Gain
–
> Gain = +0.0 dB PAR1 N/A -12dB
:
+ 6dB
Same as PAR2
NAV/PM1 Encoder
[to navigate within the menus]
NAV/PM1 Enc PM2 Enc. PM3 Enc.
[to choose values for the parameters, no need to conrm the chosen
values, which are automatically loaded during the encoders use]
8 Out-[X]
A: 5ms
[Name]
R: 0.2s
Limiter
+20dB
–
> A: 5ms R: 0.2s +20dB [Atk time] 5ms
:
200ms
[Rel time] 0.1s
:
3.0s
[Amp.] -10.0 dB
:
+20.0dB (OFF)
9 Out-[X]
Delay
=
[Name]
0.000ms
Delay
–
> Delay = 0.000ms PAR1 N/A 000.0000ms
[1 ms steps]
848.0000ms
000.0000ms
[20.8 µs steps]
000.9984mS
10 Out-[X]
Polarity
=
[Name]
Normal
Polarity
–
> Polarity = Normal PAR1 N/A Normal
Invert
Same as PAR2
To Next Page
Loading...
Need help?
General