POOL+ MANAGER App A2 - User Manual v1.0 16
6.4
HEATING
In this Menu option, you will be setting up the type/s of heating that is installed.
The options are:
Solar
Heat Pump
Gas Heater
When you enter this menu option the first thing that is displayed is:
SOLAR
1. NONE
With Solar Heating, you have the options of:
1. None
2. Separate (Independent plumbing)
3. Valve
4. Boosted (Integrated plumbing)
If you have an independent solar heating system, use ↑ or ↓ buttons to scroll
down to 2. Separate and press Enter. The controller will display:
SOLAR
START TIME XX.XX
Use the ↑ or ↓ buttons to adjust the time you would like the solar to start. Press Enter
to accept the hours, then adjust the minutes and press Enter.
If you have a system where a valve is turned to send water into the solar
panels, select 3. Valve.
If you have a Boosted (integrated) system, then scroll down to 4. Boosted and
select.
With options 3. Valve & 4. Boosted, (once you have pressed Enter to select) the
controller will display:
SOLAR
SPEED X
The controller is asking what speed you would like the pump to run at when solar
heating is asked for.
Note: If you are running a single speed pump, this question will not appear.
Use the ↑ or ↓ buttons to select which pre-set speed you would like, and press Enter.
Once you have selected the pump speed, the controller will then display:
SOLAR
START TIME XX.XX
Adjust as above.
Once you have adjusted and accepted the Solar Heating start time, the controller will
move you onto the next option.
If you have no Solar Heating installed, press Enter to accept 1. None and the
controller will move you onto the next option and display:
To Next Page
Loading...