Thermal Dynamics CutMaster 50 User Manual

WARNINGS
Read and understand this entire Manual and your employer’s safety prac-
tices before installing, operating, or servicing the equipment.
While the information contained in this Manual represents the
Manufacturer's best judgement, the Manufacturer assumes no liability for
its use.
Plasma Cutting Power Supply
CutMaster 50
Operating Manual Number 0-2805
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal-dynamics.com
Copyright 2000 by
Thermal Dynamics Corporation
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of
the publisher is prohibited.
The publisher does not assume and hereby disclaims any liability to any
party for any loss or damage caused by any error or omission in this Manual,
whether such error results from negligence, accident, or any other cause.
Printed in the United States of America
Publication Date: April 21, 2003
Record the following information for Warranty purposes:
Where Purchased:____________________________________
Purchase Date:_______________________________________
Power Supply Serial #:________________________________
Torch Serial #:________________________________________

Thermal Dynamics CutMaster 50 Specifications

General

Brand	Thermal Dynamics
Model	CutMaster 50
Category	Power Supply
Language	English