Thermann Owner’s Guide
Gas Continuous Flow Condensing Water Heaters
10
Priority Control (Change)
The temperature can only be controlled by the remote controller which has the
priority indication.
When the priority button is turned ON, that remote controller takes priority control over
the temperature settings. While hot water is being supplied, other remote controllers
cannot be turned o.
Whilst hot water outlets are open, transfer of ``priority´´ to other remote controllers
is not possible. This is safety feature.
HINTS FOR USING REMOTE CONTROLLERS FOR SAFETY AND ENERGY SAVINGS
1. Set the remote controller to a maximum of 42°C for normal bathroom use and to
prevent small children from scalding.
2. For kitchen and laundry use set the main remote controller to 60°C or the desired
temperature.
3. For showering, use settings between 37°C - 39°C and no cold water will be needed
to be mixed, and if other hot or cold water taps are used the temperature will be
maintained.
4. When bathroom remote controller is turned ON the temperature can be adjusted
between 37°C - 48°C.
Up to 50°C the temperature will increase by 1°C with each press of the UP/DOWN
buttons. The temperature can be adjusted continuously by keeping the button pressed.
Between 50°C and 75°C, the temperature is controlled by 5°C increments. The
temperature setting cannot be increased above 42°C while the hot water tap is open.
PLEASE NOTE: FOR TEMPERATURES ABOVE 50°C SCALDING CAN OCCUR
WITHIN SECONDS.
REMOTE CONTROLLER
Warning
Do not turn o the remote controller or change the water temperature while someone
is bathing or washing. That may result in scalds or burns.
To Next Page
Loading...
