Thermann 26NG50C - Remote Controller; Controller Components and Settings

Thermann Owner’s Guide
Gas Continuous Flow Condensing Water Heaters
8
REMOTE CONTROLLER
Up to three remote controllers are able to be installed with your Thermann unit for
complete control of your hot water.
Please note, units without remote controllers will be set at either 50°C or 60°C (the
exception is if the unit is installed as a solar booster. Your plumber will have set the unit to
70°C).
YST-2807
(Universal Controller)
This remote controller is intended to be used in the kitchen, laundry room, bathroom
and ensuite.
The unit will deliver the selected temperature as follows:
Kitchen Controller:
37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48, 49*, 50*, 55*, 60*, 65*, 70* and 75°C*
Bathroom Controller:
37, 38, 39, 40, 41, 42, 43, 44, 45, 46, 47, 48°C
*Only for 60°C model
ON Indicator
Indicates power is on
to the system.
UP/DOWN Button
Increase or decrease the
desired water temperature.
ON/OFF Button
Power switch to operate
this remote controller.
In Use Indicator
Indicates that a hot
water tap is open.
High Temp. Indicator
Indicates the setting
temperature is higher
than 50
゜
C.
Digital Monitor
Indicates the selected water temperature.
Error messages flash in the event of failure.
PRIORITY Indicator
Indicates this remote
controller has priority
control over the other
remote controllers.
PRIORITY Button
PRIORITY Button to set the
water temperature on this
remote controller.