7270105 Rev. 1
Preventive Maintenance Kit 2270105
3110 Series Water Jacket CO
2 Incubator
(Models 3110, 3111, 3120, and 3121)
Included in this kit (1 each unless specified):
Tools required:
Common hand tools
Caution These procedures should only be performed by qualified
personnel.
▲
Caution Turn unit off and disconnect it from power before beginning any
maintenance or service procedures.
▲
Note There are two blower scroll configurations available in some
instances. Follow the instructions pertaining to your configuration.
▲
Application
Model
Instruction Sheet
Lithium Grease 1.5 oz. #6 Solid Silicone Stopper
#6 Silicone Stopper, 1-1/4 Silicone Hose, 1/4 D x 1/8 W x 1.1 L
Blower Wheel, 3.5 x 1.5 CCW Silicone Hose, 1/4 D x 1/16 W x 1 L
Blower Wheel, 3.5 x 1.5 CCW “D” Teflon Washer, 0.31 ID x 0.625
Blower Plate Gasket HEPA Filter 5.5 x 1.5
CO2 Sensor Gasket Disposable Filter (3)
DCS IR Sensor Plate Gasket 3 x 4 1/4 Hose x 1/4 Hose Connector
Silicone Grommet, 3/8 x 1/4 (2) Corrosion Inhibitor, 800mL
Blind Silicone Grommet, 15/16 (2)
To Next Page
