9
DANGER: DO NOT USE IN THE PRESENCE OF FLAMMABLE OR
COMBUSTIBLE MATERIALS OR EXPLOSIVE GASES. DO NOT USE IN THE
PRESENCE OF PRESSURIZED OR SEALED CONTAINERS—FIRE OR
EXPLOSION MAY RESULT, CAUSING DEATH OR SEVERE INJURY.
WARNING: DO NOT HEAT ANY SUBSTANCE ABOVE A TEMPERATURE
WHICH WILL CAUSE IT TO EMIT TOXIC FUMES—DEATH OR SEVERE
INJURY MAY RESULT.
START-UP:
1. When the cordset is plugged into an outlet, the incubator is ready for use.
Turn the power switch ON. Note thermostat knob on lower right hand side
of incubator—rotate the thermostat knob clockwise to increase the
temperature, counterclockwise to lower the temperature. The status
lamp is lit when the heaters are energized.
2. Allow one hour for the temperature inside the chamber to stabilize; then
check the thermometer.
3. Repeat Steps 1 and 2 until the desired setting is obtained. The incubator
is then ready to be loaded.
4. Load the incubator so that items or specimens are spaced far enough
apart to allow for proper air circulation.
5. Insofar as possible, keep the incubator door closed in order to reduce
possibility of fungus growth starting from airborne organisms entering the
chamber.
SECTION 6
MAINTENANCE
BE ADVISED:
To Next Page
Loading...
Need help?
General
