Need help?Do you have a question about the Thermo Scientific IMH 100-S and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | IMH 100-S |
| Category | Accessories |
| Language | English |
General safety guidelines for operating Heratherm incubators safely.
Rules to follow when working with Heratherm incubators for safe operation.
Defines the incubator's intended use and lists prohibited applications.
Defines the incubator's intended use for cell and tissue cultures.
Lists prohibited uses to avoid explosion risks and other hazards.
Step-by-step guide for installing various components of the incubator.
Specifies the environmental conditions required for proper incubator installation and operation.
Lists the necessary requirements for the installation location, including ventilation and surface.
Explains the importance of adequate room ventilation for incubator operation.
Details the necessary clearances around built-in units for proper installation.
Covers mains connection, power supply, and safety considerations.
Emphasizes safety precautions when connecting to the mains power.
Step-by-step guide for connecting the incubator to the power source.
Introduces the Heratherm incubators and their different versions.
Details the built-in safety mechanisms and the door switch functionality.
Lists the safety features like sample protection, overheat cut-out, and alarms.
Describes the temperature sensors and the thermal protection function.
Guides on preparing the incubator and initiating its operation.
Step-by-step process for turning on and starting the incubator.
Introduces the control panel and its functions.
Instructions for powering the incubator on and off.
Steps to plug in and start the incubator.
Procedures for turning the incubator off and powering it down.
How to set and adjust the desired temperature for the incubator.
Details the timer feature and its three operating modes.
Instructions for launching the built-in decontamination process for IMH-S models.
Initiating manual or automatic temperature calibration routines.
Instructions for safely shutting down the incubator for extended periods.
Steps for powering off, unplugging, and preparing for shutdown.
Procedures for cleaning and disinfecting the incubator's interior and exterior.
Guidance on launching the built-in decontamination for IMH-S models.
Outlines essential maintenance tasks for optimal performance and safety.
Steps for preparing and performing temperature calibration.
Guidelines for preparing the incubator and using measuring instruments for calibration.
Step-by-step instructions for conducting a temperature comparison measurement.
To Next Page