Need help?Do you have a question about the Thermo Scientific IMH 400-S and is the answer not in the manual?
General| Orbit | 3 mm |
|---|---|
| Temperature Uniformity | ±0.5°C at 37°C |
| Power Requirements | 100-240V, 50/60Hz |
| Type | Incubated Microplate Shaker |
| Timer | 1 min to 99 hr 59 min |
| Capacity | 4 microplates (96-well) |
Essential safety guidelines for operating Heratherm incubators to prevent accidents.
Key rules to follow when working with Heratherm incubators to ensure safe operation.
Specifies environmental conditions and location requirements for incubator installation.
Defines minimum clearances needed around the incubator for proper installation.
Description of safety features, workspace atmosphere, door switch, and control system.
Steps for installing shelf systems in table-top units.
Instructions for connecting the incubator to the power supply.
Steps to prepare the incubator and perform a device check before operation.
Procedure for turning on the incubator and setting initial parameters.
Instructions for powering the incubator on and off.
Guide on how to set and adjust the desired workspace temperature.
Details on using the countdown, fixed-time, and weekly timer functions.
Procedure for launching the built-in decontamination routine.
Accessing error log, calibration, date/time, and display unit settings.
Instructions for shutting down the incubator for prolonged periods.
Guidelines for cleaning incubator exterior surfaces and internals.
Steps for manual wipe and spray disinfection, including predisinfection.
Regular inspections and checks required for optimal performance and safety.
Recommended service intervals and tasks for 3-monthly and annual servicing.
Table listing error messages, root causes, alarm responses, and clearing instructions.
To Next Page