Need help?Do you have a question about the Thermo Scientific Orbitrap Fusion and is the answer not in the manual?
General| Detector | Electron multiplier |
|---|---|
| Mass Analyzer | Orbitrap |
| Mass Accuracy | <1 ppm RMS with internal calibration |
| Scan Speed | up to 15 Hz |
| Ion Source | ESI, APCI |
| MS/MS | CID, HCD, ETD |
| Data Acquisition Modes | Full Scan, SIM, SRM, PRM, DDA, DIA |
| Software | Thermo Scientific Xcalibur |
Details compliance for Orbitrap Fusion Lumos under Low Voltage and EMC Directives.
Details compliance for Orbitrap Fusion and ID-X under Low Voltage and EMC Directives.
Official statement regarding compliance with FCC rules and operation conditions.
Information on the Waste Electrical and Electronic Equipment directive for European Union.
Instructions on how to access product manuals and online user documentation.
Information on how to provide feedback for the document through a survey or email.
Explains important notices, symbols, and caution labels used throughout the guide for safety and clarity.
Table outlining the differences in forepump requirements and available options for various MS models.
Provides contact information for technical support, customer service, and global support resources.
Step-by-step guide for attaching vacuum hose assemblies to the mass spectrometer.
Procedure for connecting forepump exhaust to the laboratory's exhaust system for solvent vapor management.
Instructions on how to properly lock the workbench wheels to ensure instrument stability.
Details the required purity, pressure, and typical consumption for Helium and Nitrogen gases.
Guide for connecting instrument gas lines for Nitrogen and Helium supplies to the MS.
Information on installing the API source and changing ionization modes without tools.
Guidance on establishing dedicated fume exhaust connections for forepumps and waste containers.
Instructions for connecting the solvent waste container to the MS drain/waste port and vent system.
Step-by-step instructions for assembling and installing the syringe pump and modular valve system.
Procedures for connecting Ethernet, USB, and power cords for the MS and peripherals.
Explains how external LC devices can start data acquisition via a contact closure signal.
Details the pin-out descriptions for various communication connectors on the MS.
Lists components included in the syringe pump and modular valve assembly kit.
Lists components included in the single mechanical pump kit.
Lists components included in the dual mechanical pumps kit.
Lists components included in the MS setup kit for communication and gas connections.
Details cord lengths, plug configurations, and ratings for various devices.
To Next Page