REC 3838 6-8
6.3 MULTIPLE PRODUCT
This optional software package allows storing of setup parameters and information for up
to 15 different products. This information is stored in memory and using the Product
menu, the AC-4000 can be switched over from one product to another in a matter of
seconds.
6.3.1 Installation
1. Turn off power at mains.
2. Open electronics controller enclosure door.
3. Locate the CPU Board (directly below the COMM Board) near the upper, back
portion of the enclosure. See Figure 4-2.
4. Remove hardware securing CPU board. Gently pull the CPU card handle,
extracting the board from the pin connectors.
5. Carefully remove the old software EPROM IC from socket U2 using an IC
extractor.
6. Insert new EPROM into socket U2. The orientation mark on the EPROM
should be toward U1 -- the large square IC.
7. If socket U3 is empty, insert the new EPROM memory IC into the socket. The
orientation mark is again toward U1.
8. Replace CPU Board in enclosure. Insure the board is in the lower slot,
properly oriented and fully seated.
9. Perform a Cold Start Procedure.
10. Verify all setups. Refer to Chapter 3 for all setup procedures. Also see the
Menu Tree drawing for menus that are available with the Multiple Products
option.
TABLE 6-4
MULTIPLE PRODUCT OPTION
Prom Description Part No. Qty.
15 Product, No Statistics, No Diverter Consult
Factory
To Next Page
Loading...