42
MM23000-series drives have user-adjustable trimpots. Each drive
is factory calibrated to its maximum current rating. Readjust the
calibration trimpot settings to accommodate lower current rated
motors.
All adjustments increase with CW rotation, and decrease with CCW
rotation. Use a non-metallic screwdriver for calibration. Each
trimpot is identified on the printed circuit board.
Calibration
Warning
Dangerous voltages exist on the drive when it is powered.
When possible, disconnect the voltage input from the drive
before adjusting the trimpots. If the trimpots must be adjusted
with power applied, use insulated tools and the appropriate
personal protection equipment. BE ALERT. High voltages can
cause serious or fatal injury.
To Next Page
Loading...