Thermo LabSystems Multiskan EX - Page 118

Comvuter Control Commands in Module 2 (ogtionalL
R Starts the computer control
Returning to keypad use
Agglutination measurement is perlbrmed. The pa
optional and defines which ones, of the 20 measur
sent in the response. The pammeter
is a string of W
The string lenah is free, the character in the middle
corresponds to pint 10.
If the strin is shorter than 20 charactere, the
undefined pints will not
absorbauces ofall 20 point
Filter selection (filters
1-8)
Current program module number is sent.
Selection of program module, n
= 1 - 4, where
i = primary EIA module
2 - agglutination module
3 = cut off module
4 = cubic spline module
Note:
Mer selecting a new program module autacalibmtion is
taking place (25
s). A new R command has lo
to enter the computer control.
V Version numbers of the software
7' Date and time
N Serial number
Acknowledgement M-ModuIe
2:
For acknowledgement messages see module 1.
Measuring with Multiskan EX under Computer Control
The computer progam, which controls Multiskan EX, must consist of modules for
-
sending a command to Multiskan EX,
-
waiting for an answer from Multiskan EX and
-
working according to a message or results.
Comouter Control Commands in
411 Modules
Modules
1 and 2 are reconlmended to use with an external computer, because all commands exist in these
modules. However other modules contain some commands:
Corn. Meaning
Multifilter nn
12 pcs
Measurement mode n=O, 1
Mcdule change n;- , 1..4
Air blank:
Column blank
Plate
measure n= , L.99
Multililtee measure
Column measure n=I.. 12
Set columnj=1..12
Initialize column
= 0
Initialize column = 1
Mixing n=00..60
Time
Serial number
Software version
Quit remote control
Agglut. measurement
MOD
l MOW 2
MOD3 MOB 4
PRIM AGG
CUT CUR
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
-
Yes
Yes
-
-
Yes
-
-
-
Yes
Yes
Yes
Yes
Yes
Yes
Yes
-
Yes
Yes
Yes
Yes
Yes
-
-
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes.
Yes
-
-
Yes
-
-
-
-
Yes
Yes
Yes
Yes
Yes
Yes
-
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com