Thermogroup 5259 - Stage 1: How to install your thermostat; Stage 2: Programming your thermostat

5259IG
WWW. WWW. WWW. WWW. WWW. WWW.
If you would like to know more about our products or services,
you can view our complete range online, WWW.THERMOGROUPUK.COM
3
Contents
Step 3: Remove the face plate
4
Step 4: Release the black steel wall plate
4
Step 7: Wire up the thermostat
5
Step 10: Clip the thermostat to the black steel wall plate 5
Step 5: Remove the black steel wall plate 5
Step 8: Detailed wiring schematic 5
Step 11: Replace the faceplate 5
Step 6: Fix the black steel wall plate to the back box
5
Step 9: Slide the thermostat into the back box 5
Step 12: Power up the thermostat 5
Function 1: Set the time & date 6
Function 2: Manual mode
7
Before you start: Advanced settings - Sensor mode, Frost protection & Program options
6
Function 3: Heating schedule
7
DO DO NOT
Ignore IP32 regulations.
Install this thermostat in a wet zone.
Turn on until all adhesives are fully cured.
Step 1: Conduit installation
4
Step 2: Get an even temperature reading
4
Stage 1: How to install your thermostat
Stage 2: Programming your thermostat
4-5
6-7
5259 is IP32 rated so is suitable for safe installation in bathrooms.
All electrical circuits in bathrooms must be protected by a 30mA RCD. The instructions we supply include as much information as possible to
ensure that all installations comply with current electrical regulations. Please call our freephone customer care line if in any doubt on 0800 019
5899.
ALL WIRING MUST CONFORM TO IEE 17TH EDITION AND
PART P REGULATIONS
IP32
! IMPORTANT SAFETY REGULATIONS !
Install a conduit before thermostat installation.
Ensure substrate is secure before inserting a groove for the conduit.
Ensure Underfloor heating is protected by an adequate RCD.