Thermopatch HS-4-C - Error Codes and Explanations; 9.2 Replacement Parts

thermopatch.com
Manual HS-4-C V.2.1 ENG Original Version QC/TDPT/mn March 2020 13
5.2 ERROR CODES
Error 1 = Temperature sensor short (0 Ohm)
Error 2 = Temperature sensor broken
Error 3 = Error in Eprom
The processor has no access to the memory for saving or read
-
ing of information.
Error 4 (HS-4-C only) = Motor timed out, not in position
or motor switch error
The correct position of the Cam Arm Motor cannot be
detected. Rotate the Cam Arm Motor Shaft checking actuation
of the Motor Detection Switch. Also, check wire connections on
the Motor Detection Switch.
thermopatch.com