Arm Installation
1. With the seat firmly in place, insert the armrest adjustment post
into the armrest housing.
2. Slide the armrest in or out to the desired position.
3. Tighten the armrest adjustment knobs located at the rear of the
scooter.
4. Ensure the armrest is firmly locked in place.
Mirror Installation
1. Insert the threaded end of the mirror into corresponding opening
on the top of the tiller.
2. Rotate the mirrors clockwise until tight.
3. Push the rubber boots located on the mirror down to cover the
threaded opening.
10
To Next Page
Loading...
General