Step 6. Place the new batteries into the battery wells, with the
terminals facing towards the front of the scooter
Step 7. Connect the red cable to the positive (+) battery terminal
(red to red).
Step 8. Connect the black cable to the negative (-) battery terminal
(black to black).
Step 9. Reconnect and tighten all screws that hold the battery
terminals.
Step 10. Ensure that the battery terminal boots are covering the
battery terminals.
Step 11. Secure the Velcro
®
tie downs over battery and securely
attach to the scooter frame.
Step 12. Reinstall the rear shroud and seat.
Seat and Tiller Adjustments
Ensure the scooter is on a level surface
Do not make adjustments while the scooter is moving
After making adjustments ensure all locks, levers and nuts
are tight and in the locked position
32
To Next Page