Thermor Trekker - Page 40

4 bars The freewheel
switch is activated
or the manual brake
disengagement
mechanism is
operated
Check the position of the
switch or lever
6 bars
The S-drive is being
inhibited from driving.
Inhibit 2 is active
This may be because
the battery charger is
connected or the seat is
not in the driving position.
See a Thermor authorized
service technician
7 bars
A throttle fault is
indicated
See a Thermor authorized
service technician
8 bars
A controller fault is
ind
Make sure that all
connections are secure.
See a Thermor authorized
service technician
9 bars
Parking brake has
bad connection
See a Thermor authorized
service technician
10 bars
An excessive voltage
had been applied to
the controller
This is usually caused
by a poor battery
connection. Check the
battery connections. See a
Thermor authorized service
technician
39