Need help?Do you have a question about the Thies CLIMA Compact WSC10 and is the answer not in the manual?
Details on how wind speed and direction are measured by the device.
Explanation of how brightness is measured using photo sensors.
How twilight is calculated from brightness sensor values.
Description of the sensor used for measuring global irradiance.
Explanation of the capacitance measurement for precipitation detection.
Information on the PT1000 measuring resistor for air temperature.
How the device uses GPS for time, date, and location data.
Method for calculating the sun's position based on GPS data.
Details on the hygro-thermosensor and humidity calculations.
Measurement of internal housing temperature using a silicon sensor.
Information on GPS receiver, RTC, and data accuracy.
Configuration of averaging periods for meteorological readings.
Guidelines for choosing the optimal location for the weather station.
Step-by-step guide for mounting the weather station hardware.
Instructions for orienting the station to geographic north.
Details on connecting the power supply and data cables.
Procedure for safely disconnecting the supply and data cable.
Using commands for configuration and data retrieval in THIES format.
Overview of MODBUS RTU communication and supported functions.
Description of data telegram formats, control characters, and separators.
Supported MODBUS functions and exception responses.
Mapping of measuring values to MODBUS register addresses.
Examples of setting parameters via MODBUS holding registers.
List and explanation of available commands for device configuration.
Sets the averaging interval for wind speed and wind direction.
Selects the command interpreter (THIES or MODBUS RTU).
Sets the baud rate for the serial communication interface.
Configures the twilight calculation mode based on brightness values.
Enables or disables the quick-start mode for the device.
Sets the heating capacity for condensation protection.
Sets the device identification number or MODBUS slave address.
Sets or verifies the password for accessing protected parameters.
Controls the green LED, indicating wind speed or darkness.
Applies an offset to correct the north direction for wind measurement.
Sets or queries the response delay for commands.
Resets the microcontroller, specifying the cause of the last reset.
Configures the frame format for serial communication.
Reads the software version of the weather station.
Initiates one-off transmission of a specific data telegram.
Selects the automatic output of telegrams at a 1-second interval.
Sets the time zone for date and time output.
General| Wind speed measuring range | 0 to 75 m/s |
|---|---|
| Wind direction measuring range | 0 to 360° |
| Humidity measuring range | 0 to 100% RH |
| Protection class | IP66 |
| Measuring principle | Ultrasonic for wind; capacitive for humidity |
| Measured variables | Wind speed, wind direction, air temperature, relative humidity, air pressure, precipitation |
| Temperature measuring range | -40 to +60 °C |
| Air pressure measuring range | 600 to 1100 hPa |
| Output | RS-485 (Modbus) |
| Operating temperature | -40 to +60 °C |
| Dimensions | approx. 150 mm |
To Next Page