EasyManua.ls Logo

Thies CLIMA Compact WSC10 - Data Averaging; Installation; Installation Site Selection

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
© Adolf Thies GmbH & Co. KG · Hauptstraße 76 · 37083 Göttingen · Germany 022028/02/23
Phone +49 551 79001-0 · Fax +49 551 79001-65 · info@thiesclima.com ·www.thiesclima.com Page 8 of 40
3.1 Data Averaging
The meteorological readings are recorded by the sensor every second. The position of the
sun is determined every 30 seconds from the GPS data. The averaging of the wind speed
and wind direction can be deactivated (instantaneous value every second) or set from 1min
to 10min. All other measured values recorded every second are subjected to a plausibility
test and made available in the output telegram without further averaging.
4 Installation of Weather Station Compact WSC10
Please note:
The working position of the Weather Station Compact WSC10 is horizontal
(plug connection underneath).
During installation, de-installation, transport or maintenance of the Weather
Station Compact WSC10 make sure that no water gets into the device and
connector.
4.1 Selection of installation site
An exposed position should be selected for this site. Measurement properties should not be
influenced by light reflections, cast shadows or the device being positioned in the lee of the
wind. Protection against lightning and overvoltage should also be provided by the customer.
The intended installation of the Weather Station requires the use of a pipe socket / pipe with
an ≤ Ø 26mm outer diameter. The inside diameter must be ≥21mm to admit the cable.
For the exact determination of wind- and brightness direction the WEATHER STATION must
be mounted in north alignment (geographic north).