GapGun MX+/SPC3d6 Connectivity Guide
© Third Dimension Confidential Document D11-678 Page 9
SPC3d6.0
5 CONNECTING THE GAPGUN MX+ VIA WIFI
5.1 OPEN SPC3D6
You must have SPC3d6 open on your PC.
5.3 YOUR COMPUTER SETTINGS
A basic knowledge of computer settings is required for setting up the GapGun MX+. Once this procedure is complete it should
not need to be done again unless there is a system change. You may also need to contact your IT department for admin rights to
the computer you are using. If at any point during the use of your GapGun MX+ connection issues arise please follow this
procedure to check the settings before contacting Third Dimension, support@third.com.
Changing your computer network settings may require a reboot of your PC to secure the changes.
If problems arise with connection between GapGun MX+ and SPC3d6 please see ‘Trouble Shooting Connection Problems’ page
27.
On rare occasions there may be other strong Wi-Fi signals in your area. To view these, a free Wi-Fi analysis tool can be
downloaded to check your local Wi-Fi connections and channels.
http://www.metageek.net/get_inssider_today/
The GapGun MX+ is setup to use channel ‘802.11b’ 2.4GHz, you may need to change this to channel ‘802.11a’ 5GHz. Please
contact your IT department or Third Dimension for further details, support@third.com.
To Next Page
Loading...