Thitronik WiPro III - Changing the handheld transmitter battery; Changing the transmitter battery of the magnetic contact; Changing the transmitter battery of the cable loop; Sequence of a burglary alarm

After completion of the alarm cycle and an alarm pause of about 30 seconds,
WiPro is armed again and responds to attempted intrusions as described above.
WiPro III Operating Instructions Page 3
1.7 Changing the handheld transmitter battery
- Unscrew the screw on the back of the handheld transmitter
and open the casing.
- Remove the printed circuit board and remove the battery.
 -Replacethebatterywithoneofthesametype(CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
1.8 Changing the transmitter battery of the magnetic contact
 -Openthecasingbygentlyleveringupbythenotch
on the narrow side of the casing.
- Remove the printed circuit board and remove the battery.
 -Replacethebatterywithoneofthesametype(CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
1.9 Changing the transmitter battery of the cable loop
-Unscrewthe2screwsonthebottomofthecableloopand
open the casing.
- Remove the battery without pulling out the printed circuit board.
 -Replacethebatterywithoneofthesametype(CR2032)
- When inserting the battery, make sure that the polarity is correct.
!!! Follow the labelling on the battery holder !!!
- Insert the black seal in the casing cover and screw the casing closed.
 -Onlytightenthescrewslightlysoasnottocrushthesealtoomuch.
1.9.1 Sequence of a burglary alarm
If an opening which is secured with a wireless magnetic contact is opened,
a cable loop is cut or removed from its holder or a cab door is opened
(if connected to the input for the interior lighting not possible
until at least 60 seconds after arming the system!!) when
the system is armed, it will display this as a burglary alarm.
The siren and the horn (depending on the vehicle type)
sound(s) for about 30 seconds.
The vehicle indicators ash for about 180 seconds.
The status LED ashes for about 180 seconds.
GB