1.9.10 Anti-jamming alarm
WiPro III applies intelligent functions and evaluation algorithms to detect illegal
interference or disruptions of the receiving frequency.
An alarm is triggered if necessary without interfering with the trouble-free operation
of the WiPro III and its components in any way.
If you frequently use your vehicle in areas where the WiPro III is exposed to illegal
traconitstransmissionfrequency,thismayresultinundesiredalarms.
RefertoChapter1.5onPage3oftheinstallationmanualtolearnhowyoucandisable
the anti-jamming function.
2. Alarm storage
The alarm storage allows you to review all incidents that occurred while you were away
from your vehicle. When sounding a long, continuous tone followed by two short tones
from the internal siren when switched to “disarmed”, the alarm system has recorded
a previous alarm.
To determine which type of detector triggered the alarm, check the status LED before
puttingthealarmsystembackintooperation.ThestatusLEDusesasequenceofashes
to indicate which type of detector triggered the alarm. You can use the table below to
attributeanalarmtoaspecicdetector.
If the tone described above sounds while the system is being “disarmed”, the alarm
storage will be erased by the next “arming” process.
1ashfollowedbya5secondpause… Reason for alarm:
Cabdoors(CANbus)
2ashesfollowedbya5secondpause… Reasonforalarm:
Wireless magnetic contact
3ashesfollowedbya5secondpause… Reason for alarm:
Wireless gas alarm
4ashesfollowedbya5secondpause… Reason for alarm:
Radio cable loop
5ashesfollowedbya5secondpause… Reason for alarm:
G.A.S.-pro
8ashesfollowedbya5secondpause… Reason for alarm:
Panic alarm
9ashesfollowedbya5secondpause… Reason for alarm:
Interfering transmitter
10ashesfollowedbya5secondpause… Reason for alarm:
Pro-nder(SMS“alarm”)
11ashesfollowedbya5secondpause… Reason for alarm:
Input for interior lighting
WiPro III Operating Instructions Page 6
GB