2. Press [PAGE].
ð
The kit volume appears in ‘Lxx’ format on the display.
3. Adjust the volume using the buttons [–] and [+] in a range from 00 bis 32.
The setting is automatically stored.
To turn the Reverb effect on or off, proceed as follows:
1. Press [MODE] repeatedly until the LED [KIT] lights up.
ð
The display shows the kit number.
2. Press [PAGE].
ð
The current Reverb setting appears in the display (‘roN’: on or ‘roF’: off).
3. Change the setting using the buttons [–] and [+].
The setting is automatically stored.
Turning Reverb on / off
Operating
MPS-150
29
To Next Page
Loading...
Need help?
General