To programme a certain Voice for a pad, proceed as follows:
1. Press [MODE] repeatedly until the LED [VOICE] lights up.
2. Hit the respective pad to activate it.
ð
The display shows the number of the currently assigned Voice.
3.
Select the desired Voice using the buttons [–]/[+] (see
Ä
Chapter 11.1 ‘ Voice list’
on page 44).
The setting is automatically stored.
Only Voices from group 1 – group 4 can be assigned to a Hi-Hat. The display shows
‘H-I’.
Assigning a Voice
Operating
e-drum module
30
To Next Page
Loading...
