4. Activate the desired pad using the pad select buttons or by striking it.
ð
The symbol for the pad flashes in the display.
5. Use the rotary control [–] / [+] to set the sensitivity of the pads to the desired value in a
range from 1 to 127.
6. Activate the next pad or press [ENTER] to jump to the ‘Dynamic Range’ parameter.
If you step on the hi-hat pedal quickly, the usual chick sound is produced, without playing the
pad additionally (closed hi-hat). When you release the pedal, the splash sound is generated
(open hi-hat). Both pressure and opening point can be set via the drum module.
1. Press the [KIT] button to change to the kit mode, followed by the [SETUP] button.
2. Repeatedly press the [ENTER] button or turn the rotary control [–] / [+] until the menu
item ‘Advanced’ appears in the display.
3. Press [SETUP] for confirmation to open the setup menu.
4. Press the [H-PEDAL] button to specify the pressure point for the closed hi-hat.
ð
The parameter ‘PDL Bottom’ and the current value in ‘000’ format are indicated in
the display. The pedal symbol is flashing in the display.
Hi-Hat response characteristic
Operation
MPS-500
41
To Next Page
Loading...
