5. Step on the hi-hat pedal or press the [H-PEDAL] button and use the rotary control [–] / [+]
to set the pressure point to the desired value in a range from 50 to 0.
6. Press [ENTER] to confirm the setting.
7. Repeat steps 1 to 4 and then press the [HI-HAT] button to specify the opening point for
the open hi-hat.
ð
The parameter ‘PDL Top’ and the current value in ‘000’ format are indicated in the
display. The pedal symbol is flashing in the display.
8. Step on the hi-hat pedal or press the [HI-HAT] button and use the rotary control [–] / [+]
to set the opening point to the desired value in a range from 127 to 51.
The drum module allows you to adjust the dynamic range of the individual pads and thus, the
signal-to-noise ratio.
1. Press the [KIT] button to change to the kit mode, followed by the [SETUP] button.
2. Repeatedly press the [ENTER] button or turn the rotary control [–] / [+] until the menu
item ‘Advanced’ appears in the display.
3. Press [SETUP] for confirmation to open the setup menu.
ð
Use the rotary control [–] / [+] to change to the second parameter ‘Dynamic Range’.
Dynamic range
Operation
e-drum modul
42
To Next Page
Loading...
