4. Activate the desired pad using the pad selection buttons or by striking it.
ð
The symbol of the pad flashes in the display.
5. Use the rotary control [–] / [+] to adjust the dynamic range of the pads to the desired
value in a range from 1 to 127.
6. Activate the next pad or press [ENTER] to jump to the ‘Trigger’ parameter.
The drum module allows you to adjust the velocity of the individual pads, i.e., the ratio
between strike pressure and resulting volume.
1. Press the [KIT] button to change to the kit mode, followed by the [SETUP] button.
2. Repeatedly press the [ENTER] button or turn the rotary control [–] / [+] until the menu
item ‘Advanced’ appears in the display.
3. Press [SETUP] for confirmation to open the setup menu.
ð
Use the rotary control [–] / [+] to change to the third parameter ‘Trigger’.
4. Activate the desired pad using the pad selection buttons or by striking it.
ð
The symbol of the pad flashes in the display.
5. Use the rotary control [–] / [+] to adjust the velocity of the pads (Linear, Exp1, Exp2, Log1,
Log2, Spline).
Velocity
Operation
MPS-500
43
To Next Page
Loading...
