THOMSON 500015 - F - USE; 1 - USE WITH A CONTROL DEVICE

27
EN
F - USE
MOTORISED KIT WITH ARTICULATED ARMS
FOR SINGLE OR DOUBLE LEAF SHUTTERS
1 - USE WITH A CONTROL DEVICE
Use the supplied remote control, a wired control
switch,orotherprogrammedtransmittertocontrol
thesystem.
With a remote control or a radio control device
• Opening:
1-Presskey onyourremotecontrol.
2-Theshutteropens.
3-Unless you do otherwise, the shutter stops
whenit’sopen.
4-Ifit’sopening,presskey tostopshutter.
• Closure:
1-Presskey onyourremotecontrol.
2-Theshutterstops.
3-Unless you do otherwise, the shutter stops
whenit’sclosed.
4-Ifit’sclosing,presskey tostopshutter.
With a wired 2 stage button
Changeswitchpositiontoopentheshutterwhenit’s
closed,andtocloseitwhenit’sopen.Whenusing
this type of control switch, the radio control does
notoperate.
With a wired 2 stage button
Press either of the two buttons to open or close.
Using with type of control switch, there is no
incompatibilitywiththeradiocontrol.
With a 3 stage control device
The two end positions close or open, the central
position stops the shutter. If the switch is blocked
tosidepositions(3stagebuttonstable),theshutter
automatically stops moving, you don’t need to
bring it back to central position. However, if the
switch remains to end positions, the radio control
isblocked.
To use a radio control device when a wired
control switch is connected, the switch must
have 3 positions. Keep pressed to operate the
system (the button returns in central position
when it’s released) OR, the switch has 2
pushbuttons.
2 - USE WITH THOMBOX
• WhenyoupairyourgearmotorwithaThombox,
this will appear in the widget «Opening
modukles».Itwillalsoappearas«Actuator»
in rules creator. You can also create rules to
manageopeningandclosureofyourshutter.
• When you pair your remote control with a
Thombox,itwillappearinthecontrolpanel,but
it’s also visible in rules creator of «Controls»
device.Youcanestablishrulesthatwilltriggere
withyourremotecontrolbuttons.
3 - DELETING ITEMS FROM REMOTE
CONTROL MEMORY
Ifyouwanttodeleteoneremotecontrolleddevice,
repeat the programming phase described in this
guidewiththechannelconcerned.Ifyouprogramme
2 times a Thomson device on the same channel,
thiswillbecancelledfromchannel.
4 - DELETING ALL ITEMS FROM REMOTE
CONTROL CHANNEL
• If you want to delete all remote controlled
devices,presstheon/offswitchofthechannel
concernedfor3secondes.
• Release the buttons, and press again for 3
secondstheon/offkeys.
Everychannel-controlleddevicewillbedeleted.