THOMSON ST585 V6 - Connecting a Computer Using the Ethernet Cable

E-DOC-CTC-20080627-0003 v1.0
Chapter 3
Adding a New Computer to your Network
20
3.1 Connecting a Computer Using the Ethernet Cable
Requirements
> Your computer must have a free Ethernet port.
> Your computer must be configured to obtain an IP address automatically. This is the default setting.
Ethernet cable
In your package, you will find a cable with yellow connectors. This is the Ethernet cable.
Procedure
Proceed as follows:
1 Connect one end of the Ethernet cable to (one of the) yellow Ethernet port(s) of your Thomson Gateway:
2 Connect the other end of the Ethernet cable to your computer.
3 Your computer is now connected to your network. No additional configuration is needed.
Ethernet
1432
DSLReset
1
2
4
3
ON/OFF