E-DOC-CTC-20080627-0003 v1.0
Chapter 7
Troubleshooting
51
Hardware Reset
Proceed as follows:
1 Make sure the Thomson Gateway is turned on.
2 Use a pen or an unfolded paperclip to push the recessed Reset button. Push it until the Power LED lights
red - this will take about 7 seconds.
3 Release the Reset button.
4 The Thomson Gateway restarts.
!
Your system administrator may have disabled the physical reset button of the Thomson
Gateway. In this case, a hardware reset to defaults is not possible.
Ethernet
1432
DSLReset
1
2
4
3
ON/OFF
To Next Page