THOMSON ST585 V6 - Configuring Upnp on the Thomson Gateway

E-DOC-CTC-20080627-0003 v1.0
Chapter 5
Getting the Most Out of Your Thomson Gateway
32
5.1.3 Configuring UPnP on the Thomson Gateway
Introduction
On the Thomson Gateway Web Interface you can:
> Enable/Disable UPnP
> Extended Security
Enable/Disable UPnP
Proceed as follows:
1 Browse to the Thomson Gateway Web Interface.
2 On the Toolbox menu, click Game & Application Sharing.
3 Under Universal Plug and Play:
 Select the Use UPnP check box, to enable UPnP.
 Clear the Use UPnP check box, to disable UPnP.
4 Click Apply.
Extended Security
If Extended Security is enabled only limited UPnP operation between the host and the Thomson Gateway is
allowed:
> A local host is not allowed to connect/disconnect the Thomson Gateway Internet connection. You can
then only connect/disconnect the Internet connection via the Thomson Gateway Web Interface
> Address translation mappings can only be added or changed via UPnP for the host on which the UPnP
application is running.
Enabling Extended Security
Proceed as follows:
1 Browse to the Thomson Gateway Web Interface.
2 On the Toolbox menu, click Game & Application Sharing.
3 Under Universal Plug and Play, select Use Extended Security.
4 Click Apply.