THORENS TD-150 - Stylus overhang; VIII. Pick-up arm adjustments; Mounting the counterweight

©) Bring the arm over a record (caution: choose a worn
record) and adjust the vertical tracking angle according
to the instructions of the cartridge manufacturer.
Make sure that the rear of the shell cannot contact a
warped
record.
If
necessary,
increase
the
vertical
tance between the stylus tip and the bottom of t
with the help of spacers (see No. 1 above).
4)
Tighten
small
set
screw
B,
= Fig. 7, Adjustment of plug-in shell.
For
optimum
tracking,
the
stylus
overhang
on
the
TP-13
pick-up
arm
should
be
18
mm
(45/64").
It
is
ily
checked
by
making
use
of
the
contre
adaptor
(part
$
800-522):
the
adaptor
on
the
centering
pin
in
the
position
for
large
hole
recorde
and
movo
the
pick-up
farm
to
this
centering
pin.
Teh
exact
overh:
‘obtained
when
the
stylus
tip
is
just
striking
the
‘upper
circle
of the
adapter
(soe
Fig.
7). Tighten
the two
screws
A.
VII Pick-up arm adjustments
© Mounting the counterweight
AAs
a
precaution
against
damage
in
transit,
the
counterweight
(part
$
808-223)
is
packed
se
in box D with its set knob
A (S 608-211).